|
|
Post by btrantow on Dec 11, 2023 12:38:25 GMT -6
Hello all, new to the forum. I want to install a Power Bubbles aerator in my bait wells and wire it to one of the Accessory pre-wired switches on the console. This seems simple enough, but looking at the switch panel where do I hook up the negative wire? Assuming a connect the hot power wire to the blade terminal. Any help would be appreciated! Bryan
|
|
|
|
Post by btrantow on Dec 11, 2023 12:38:55 GMT -6
|
|
|
|
Post by yessnoo on Dec 11, 2023 17:15:59 GMT -6
I am not familiar with the exact wiring setup on these newer seapros however the negative wire ultimately needs to connect somehow to the negative battery post. This could be done directly to the battery terminal or more conveniently there may be a negative terminal bus bar somewhere in the console that you could hook it to. If not hopefully there is at least a ground terminal near the battery you could hook it to instead of directly to the battery
|
|
|
|
Post by gnrphil on Dec 12, 2023 10:07:23 GMT -6
You can hook up the ground/negative wire to any common ground point, such as battery terminal or fuse box.
|
|
