Sea Pro Seat Slide Needed - Not Standard?

[Deleted]

All: I have a 2007 19.5' foot Sea Pro and the seat slide broke. There are two sets of holes on the seat where a new plate may be attached, 12.25" x 5' or 8.5' x 11". I have looked through the inventory of Garelick and Springfield where they give the standard size as 12" x 5". Their plates does not seem to have enough room for that extra quarter inch if I were to expand the hole.

Anyone have a source for a seat slide manufacturer for Sea Pro boat seats?

Worst case I could replace the pedestal, bracket and seat, but the cost is $350+. A bracket would run me about $100.

Thanks. Linkster

[T-Topless]

They used Garelick in earlier years, unless Brunswick changed it in later years like years like your 2007.