|
|
Post by how2fish on Jul 13, 2020 6:51:48 GMT -6
I have no power to the motor , or any of the gauges , tilt trim etc. I have a 2002 SV1900 and after reading some posts on the forums I found an entry . That indicated to check back by the transom on starboard side. This was for a (sv2100) that has a battery switch, and that below battery switch is the main power lead going to the dash panel switches. , it has an inline fuse. Mine is a 2002 SV1900 and does not have a battery switch but does have a inline fuse coming from the battery..we inspected that and found it blown and have replaced it however now the bilge works but the motor nor the gauges will now work and they were before replacing the breaker..anyone have any ideas where to start looking for the problem ?
|
|
985crabs
Captain
2000 V1900 Bay Series, Yamaha 150 Carb. 2
Posts: 1,311
|
Post by 985crabs on Jul 13, 2020 8:53:52 GMT -6
On mine, all the breakers and switches are daisy-chained together. My first thought would be to go find the wire that came off its post and is no longer connected to anything.
|
|
|
|
Post by gnrphil on Jul 13, 2020 9:01:18 GMT -6
Sounds like you may have left a wire disconnected, go back and check everything you did. Do you have 2 batteries ?
|
|
|
|
Post by how2fish on Jul 13, 2020 10:08:53 GMT -6
Actually have I one cranking battery and two trolling motor batteries but we didn't do anything with them. I think all the breakers are reconnected but I did remove the old horn, but I don't think that could affect it? Also one of the breakers I replaced was a 4 amp that replaced with a 10 amp just until I could order a replacement 4 amp that couldn't cause the power loss or could it? Also after replacing the breaker the bilge pump works but the gauges and the motor don't .
|
|
|
|
Post by gnrphil on Jul 13, 2020 19:59:49 GMT -6
I would think (and pretty sure mine is) that the engine andgauges would be on a different circuit than the bilge pump and the rest of the sea pro wiring. Maybe a problem with the key switch.
|
|
|
|
Post by how2fish on Jul 14, 2020 14:29:47 GMT -6
Thanks for the info !
|
|
