|
|
Post by troutslayer on Jun 12, 2018 19:02:37 GMT -6
Anybody know who made the steering wheels for the 2006 model bay boats, specifically the 1900 sv. Mine is 13.25 diameter 5 spoke with finger grip and would like to add a knob for steering. Has anyone added a knob and which one. Wondering if an Edison ball bearing will fit on one of the finger grip knobs.
|
|
|
|
Post by troutslayer on Jun 13, 2018 4:22:59 GMT -6
Meant to say will that knob fit on a finger grip steering wheel.
|
|
|
|
Post by Juan on Jun 13, 2018 6:31:44 GMT -6
Is it one of these?  |
|
|
|
Post by troutslayer on Jun 13, 2018 9:22:57 GMT -6
Yes my steering wheel has the finger knobs on its underside was wondering if a clamp on knob will work with all those bumps. May just buy a whole new wheel, mine has a tiny bit of corrosion. Just wondered who the steering wheel was made by, I thought they might have a clamp on knob that works with their wheel.
|
|
|
|
Post by Juan on Jun 13, 2018 11:50:56 GMT -6
IDK, They might make one but all the steering knobs I've seen on wheels that have the finger indention have been bolted through the wheel. I'm assuming the clamp on bracket might not pull up tight on the finger indentions. I pulled that picture from eBay where that wheel with the knob is listed for $49.
|
|
|
|
Post by gnrphil on Jun 13, 2018 13:23:02 GMT -6
I think most of the hardware is from Gemlux, the wheel might be too. I don't see a knob on there website though.
|
|
|
|
Post by troutslayer on Jun 13, 2018 15:43:18 GMT -6
Thanks, Gemlux is who I bought my compartment locks from I will contact them directly, thanks for the help. Anyone know the correct seal kit for hh4514 Baystar plus steering helm? Is it HP6032 or HS5176 my helm is seeping a little at the shaft seal.
|
|
